Call Us Today!
(425) 999-9417

If you’re a homeowner and consider yourself a DIY enthusiast, you may run into the option of installing an AO Smith electric water heater. In this article, we’ll go over the ins and outs of installing an electric water heater. However, it is important to remember that if the AO Smith hot water heater installation seems too complicated or big to do yourself, it is always best to call in the professionals.

Finding an Ideal Location

The first thing to note about installing an electric water heater is that it is much easier to install than a gas water heater. This is because you won’t have to vent any gas or deal with any combustible fuels. Another important factor to consider is where you’ll be installing the water heater. In contrast with gas water heaters, the AO Smith electric water heater can be located or installed almost anywhere in the home. However, make sure that the area is clean and clear of any debris or flammable items.

What You’ll Need

When you start to install your water heater, it’s always a good idea to have the manufacturer’s instructions. Once you find a spot for the water heater, you will have to level it as you place it in a vertical position for the AO Smith installation. If you have trouble finding a suitable area, just make sure it’s not in an area where weather or freezing temperatures can be a factor, such as a garage. Before you start working on your electric water heater, make sure that you have the following tools:

  • Screwdrivers
  • Wrenches
  • Level
  • Wire strippers
  • Pliers
  • Pipe cutter
  • Multimeter
  • Hacksaw
  • Teflon tape or pipe joint compound
  • Garden hose for draining
  • Electrical conduit
  • Plastic twist caps

Quick Tips That Make a Difference

Make sure that you install your water heater where you’ll have sufficient access for any maintenance or future repairs. Remember to also shut off any water or electricity before you start the install. The Teflon tape or piping compound will be used to create tight seals around the pipes. This will prevent leaks. You can connect the water lines straight to your hot and cold water at the top of the water heater. These pipes will usually be made of PVC materials, depending on your piping system. You can install the shutoff valve toward the end of the cold-water line. Make sure the shutoff valve is not located between the expansion tank and the water heater. Next, install the temperature and pressure relief valve close to the floor not exceeding six inches away from the floor. As soon as you’re finished setting up the water supply, you can connect the power lines to the heater’s junction box. This can be found at the top of the electrical water heater. Make sure that you follow the instructions found on the water heater’s electrical diagram. In order to finish up the job, you’ll have to fill the tank with water. You can turn the hot water faucet on for about two minutes to clear any air in the waterline.

Contacting the Professionals

Because of their experience and professional plumbers, you can contact the Green House Plumbing company for all your Water Heater Repairs and Installations in Bellevue, or follow us on Facebook or Call us today at (425) 999-9417.